Alltek Roller LG400 – Confort thermique

Typical Spreadability

1 litre/m² per mm of thickness.

Density

0,8 +/- 0,1 kg/l

Solid Content

• Solid content by mass: 50%
• Solid content by volume: 60%

Application conditions

• +8°C to +35°C
• Max. relative humidity 70%

pH

8 +/- 1

Cleaning tools

With water

Drying

• 24 to 48 h on average, depending on application thickness, temperature, ventilation, humidity and substrate type. Sanding and recoating: after complete drying.

Recommended thicknesses

• Min. thickness: 1 mm
• Max. thickness: 10 mm

• Thanks to its technology, Alltek Roller LG400 has an exceptionally low thermal conductivity coefficient of 0.09 W/mK. It thus provides insulation that is 5 times stronger than traditional plaster. The possibility to apply it very thickly means thermal resistance and the thermal comfort of the building can be strengthened.
• Classification: group III class 2 as per the standard AFNOR NF T 30-005, in compliance with the standard AFNOR NF T 30-608 and NF EN 16566.

• 12 litre plastic bucket.
• Shelf life is 1 year in unopened original packaging, protected from frost and extreme heat.

•  VOC content: < 1 g/l.
•  Indoor Air Emission Classr

Substrates:

• Application on all substrates: concrete, aerated concrete, mortar, plaster, gypsum blocks, plasterboard, cement, cinder blocks.

Preparation of substrate:

• The substrates, preparatory work and application conditions must be compliant with applicable building trade regulations (e.g. DTU) and standards.

Application tips:

• Immerse a honeycomb mesh roller in the coating and apply liberally to the substrate.
• Then smooth the plaster with a flexible spatula and, if necessary, sand after complete drying with a fine grain sandpaper (100 – 150)

Recommendations:

• It is recommended that a finish coat with Alltek LF50 or Alltek LM150 is applied before painting.
• Ensure adequate ventilation to remove excess moisture and accelerate drying.