ICP Alltek

  1. ICP Alltek
  2. Products
  3. Airless fillers
  4. Alltek Alpha F

Alltek Alpha F

Airless fine sprayplaster

DESCRIPTION

Lightweight roughing and finishing plaster for airless application. Alltek Alpha F is a ready-to-use white plaster in paste form.

USE

  • Coating for interiors, walls and ceilings of all smooth standard substrates.
  • Ideal on plasterboard.
  • Smooth finish after smoothing and sanding.
  • No smoothing required, the coating swells on application, producing on drying slightly stippled, regular surface that can be coated by all types of paint.
  • Manual application possible.
Typical spreadability 0.5 to 0.8 kg/m² per layer depending on smoothness of substrate.
Recommended thicknesses
  • Min. thickness: 0,2 mm
  • Max. thickness: 1 mm
Packaging 25kg plastic bucket

Détails

TECHNICAL SPECIFICATIONS

Typical Spreadability

0.5 to 0.8 kg/m² per layer depending on smoothness of substrate.

Density

1.7 +/- 0,1 kg/l

Solid Content

  • Solid content by mass: 67%
  • Solid content by volume: 45%

Application conditions

  • +8°C to +35°C
  • Max. relative humidity 70%

pH

8 +/- 1

Cleaning tools

With water

Drying

  • 12 to 24 h on average, depending on application thickness, temperature, ventilation, humidity and substrate type. Sanding and recoating: after complete drying.

Recommended thicknesses

  • Min. thickness: 0,2 mm
  • Max. thickness: 1 mm

CHARACTERISTICS

  • Ready to use
  • Easy to apply.
  • Ergonomic and rapid application, minimum retouching
  • Excellent adhesive properties
  • Very good spreading power
  • Easily sanded
  • Fire rating: A2-s1, d0 as per European standard EN 13501-1.
  • Classification: group III class 2 as per AFNOR NF T 36-005, in compliance with the standard AFNOR NF T 30-608.

PACKAGING AND STORAGE

  • 25kg plastic bucket
  • Shelf life is 9 months in unopened original packaging, protected from frost and extreme heat.

ENVIRONMENTAL INFORMATION

  • VOC content: < 1 g/l.
  • Indoor Air Emission Class

METHOD OF APPLICATION

Substrates:

  • Wallboard and plasterboard after filling of joints, sprayed plaster.
  • As finish on concrete.
  • Wood and wood products, old painted substrates in good condition.

Preparation of substrate:

  • The substrates, preparatory work and application conditions must be compliant with applicable building trade regulations (e.g. DTU) and standards.

Application tips:

  • Stir before use if necessary.
  • All airless pumps, flow rate > 5 L (do not use filter).
  • Airless 25 to 31 nozzles, depending on condition of substrate and equipment used (follow the manufacturer’s advice).
  • Flexible smoothing knife of “Parfaitliss” type or similar.
  • Sanding with grain size 180 to 220.

Recommendations:

  • Ensure adequate ventilation to remove excess moisture and accelerate drying.

HEALTH AND SAFETY

The safety information sheet is available from: www.icp-alltek.com/en-gb/documentation/